Hayter 48 model 488t

[Brianmidgley]

As the above need to change drive belt but cannot get it over the 5 speed hub operating cable is connected to it
Brian

[Mick]

Hi Brian, and welcome to TGMforum.

You'll notice the cable is running through a little guide to make it run at the correct angle.  You'll need to undo the small bolt (54) on that guide and the long nut (109) (where the cable chain goes in to the gearbox) that holds that guide onto the gearbox spindle, then rotate the chain part anti clockwise to unscrew the end of the speed cable from the gearbox.

[Brianmidgley]

Many thanks for the info now just have remove the plastic shield found two bolts hope for the best
Thanks Brian have a good xmax